24

Removing and replacing the Warming

Drawer

Electrical shock hazard can occur

and result in serious injury or death. Disconnect

appliance from electric power before cleaning

and servicing the warming drawer.

To remove the warming drawer:

1. Turn power OFF to the appliance before removing the
warming drawer.
2. Open the warming drawer completely.
3. On left warming drawer rail, locate black release lever
and press up with finger while pulling out slightly on the
oven drawer handle. On right warming drawer rail,
locate black release lever and press down with finger
while pulling out slightly on the warming drawer handle
(See Fig. 1).
4. The warming drawer should now be released from the
rails. Remove warmer oven drawer (using level &
square motion) completely out and away from the
appliance.

To replace the warming drawer:

1. Pull the bearing glides to the front of the outer
compartment glide channels until they snap into place
(See Fig. 3).
2. Carefully line up both sides of the warming drawer
glide rails to the outer compartment glide channels
located inside the empty warming drawer compartment
(See Fig. 2).
3. While holding the warming drawer level and square
using the warming drawer handle, push (do not force)
the warming drawer all the way into the outer
compartment glide channels all the way into the range.
Open the warming drawer again to verify the glides
have seated.
4. If you do not hear the levers click or the bearing
glides do not feel seated remove the warming drawer
and repeat steps 1 through 3 again. This will minimize
possible damage to the bearing glides.
Left-hand rail and release
Right-hand rail and release
Warmer
drawer
handle
Left-hand channel
Right-hand channel
Fig. 1
Fig. 2
Fig. 3
Warming Drawer (some models)