KitchenAid KUDS01VM Loading Silverware Basket, To install medium insert, To install small insert

Models: KUDS01VM

1 44
Download 44 pages 44.96 Kb
Page 11
Image 11
To install medium insert

To install medium insert

1.Place the medium insert end legs under the 2nd from the right wire as shown below.

IMPORTANT: Make sure that the curved wires, on the bottom of the insert, fit over a wire in the bottom of the rack as shown.

2.Push down on insert until handle fits against outer rack edge.

3.When center tab under handle locks in under the middle side rack wire, the insert is in place. (See illustration.)

To install small insert

Front view from inside rack

1.Place small insert in front of rack so that the feet on the back of the insert hook under the 2nd wire from the front, and the curved front edge of the insert is aligned with the center wire on the front side of the rack. (See illustration.)

2.Push down on insert until handle fits against outer rack edge.

Front view from inside rack

3.When center tab under handle locks in under the middle side rack wire, the insert is in place. (See illustration.)

SURE-HOLD®mesh sack

This sack hangs on the front of the bottom rack. Use it to hold small items that could otherwise “fly” around inside the dishwasher during a cycle.

Loading Silverware Basket

Load the silverware basket while it is in the bottom rack or take the basket out for loading on a counter or table. (See recommended loading pattern shown.)

NOTE: Unload or remove the basket before unloading the racks to avoid spilling water droplets on the silverware.

Load items with covers down, using the separators, to prevent silverware nesting.

Place small items such as baby bottle caps, jar lids, corncob holders, etc., in the section(s) with hinged cover(s). Close the cover to hold small items in place.

When covers are up, mix items in each section of the basket with some pointing up and some down to avoid nesting. Spray cannot reach nested items.

IMPORTANT: Always load sharp items (knives, skewers, etc.) pointing down.

NOTES:

Do not load silver or silver-plated silverware with stainless steel. These metals can be damaged by contact with each other during washing.

Some foods (such as salt, vinegar, milk products, fruit juices, etc.) can pit or corrode silverware. Run a rinse cycle if you do not have a full load to wash immediately.

11

Page 11
Image 11
KitchenAid KUDS01VM Loading Silverware Basket, To install medium insert, To install small insert, SURE-HOLD mesh sack