4.Push the right end of the motor mounting plate up and snap it into the spring tab.
NOTE: The spring tab should be outside the slot in the mounting plate.
A
7.Go to the “Make Electric Power Supply Connection to Range Hood” section.
Install Range Hood In-Line (External Type)
Blower Motor
NOTE: Your range hood requires you to purchase either an internal type or an
B
A. Motor mounting plate
B. Spring clip
5.Align mounting holes in motor mounting plate with motor mounting clip nuts and install 6 x 16 mm screws and
6.4 mm lock washers (quantity 2 for single motor; quantity 5 for dual motor).
C 
B
A
A. Screw with lock washer
B. Mounting hole in motor mounting plate
C. Clip nut (6 mm)
6.Attach power supply connector from the range hood to the connector on the blower motor assembly wiring box.
A 
B 
A. Wiring box connector
B. Power supply connector from range hood
Prepare for Mounting the In-Line Blower System
The
NOTE: The mounting hole locations must span the studs. Additional stud framing may be required. Plywood may be used to span open areas between ceiling joists or roof rafters to aid installation. This structure must be strong enough to support the weight of the
Prepare the In-line Blower System
WARNING
Excessive Weight Hazard
Use two or more people to move and install
Failure to do so can result in back or other injury.
1.Using 2 or more people, move the
2.Remove the 10 screws from the front cover of the
3.Remove the front cover of the
NOTE: To make the blower motor housing easier to mount, the blower motor assembly can be removed. If you do not want to remove the blower motor assembly, proceed to “Install
4.Disconnect the motor electrical plug from the blower motor assembly.
5.Remove the screws that secure the blower motor assembly to the
6.Pull the spring clip to release the blower motor assembly. Remove the blower motor assembly from the housing and place it on a covered surface.
10
