KitchenAid Pro LineTM installation instructions Use and Care Information, Check operation

16. Install the filters.

•Remove the filters from the box and remove the white protective coating from the filters.

Note: Use two hands to install filter, one to pull and turn the knob, the other to hold the filter in place so that it doesn’t fall onto the cooktop.

•Grasp one of the filters so that the knob faces down and toward the back of the hood.

•Insert the filter end without the knob into the retaining channel in the front of the hood.

•Pull and turn the knob to the left (counterclockwise) so that the locking lever does not protrude from the filter.

•Insert the knob end of the filter into the retaining channel in the back of the hood.

•Turn the knob to the right (clockwise) to lock the filter in place.

•Repeat for remaining filters.

Check operation

17. Turn power on.

18. The canopy hood controls are located on the right- hand underside of the canopy.

controls

filters

19. Check the operation of the range hood:

Move light switch to

“1” position. The light should turn on.

Move blower switch to “1” position. The blower should operate.

Move the blower speed switch to: “1” position for low speed, “2” position for medium speed, or “3” position for high speed.

Move blower and light switches to “0” position to turn blower and light off.

If range hood does not operate:

Check that the circuit breaker is not tripped or the house fuse blown.

Disconnect power supply. Check that wiring is correct.

To get the most efficient use from your new range hood, read the “Use and Care Information” section.

Keep your KitchenAid

Installation Instructions and Use and Care Guide close to range hood for easy reference.

Use and Care Information

WARNING — To reduce the risk of	WARNING — TO REDUCE THE	SMOTHER FLAMES with a close-
fire or electrical shock, do not use	RISK OF A RANGE TOP GREASE	fitting lid, cookie sheet, or metal
this fan with any solid-state speed	FIRE:	tray, then turn off the burner. BE
control device.	Never leave surface units	CAREFUL TO PREVENT BURNS. If
WARNING — TO REDUCE THE		the flames do not go out
	unattended at high settings.
		immediately, EVACUATE AND
RISK OF FIRE, ELECTRIC SHOCK,	Boilovers cause smoking and
		CALL THE FIRE DEPARTMENT.
OR INJURY TO PERSONS,	greasy spillovers that may ignite.
OBSERVE THE FOLLOWING:	Heat oils slowly on low or	NEVER PICK UP A FLAMING PAN
Use this unit only in the manner	medium settings.	— You may be burned.
intended by the manufacturer. If	Always turn hood ON when	DO NOT USE WATER, including
you have questions, contact the	cooking at high heat or when	wet dishcloths or towels — a
manufacturer. Before servicing or	cooking flaming foods.	violent steam explosion will
cleaning unit, switch power off at	Clean ventilating fans frequently.	result. Use an extinguisher ONLY
service panel and lock the service		if:
	Grease should not be allowed to
disconnecting means to prevent
	accumulate on fan or filter.	You know you have a Class ABC
power from being switched on
		extinguisher, and you already
accidentally. When the service	Use proper pan size. Always use
		know how to operate it.
disconnecting means cannot be	cookware appropriate for the size
locked, securely fasten a	of the surface element.	The fire is small and contained in
prominent warning device such as	WARNING — TO REDUCE THE	the area where it is started.
a tag to the service panel
	RISK OF INJURY TO PERSONS IN	The fire department is being
CAUTION: For general ventilating
	THE EVENT OF A RANGE TOP	called.
use only. Do not use to exhaust	GREASE FIRE, OBSERVE THE	You can fight the fire with your
hazardous or explosive materials	FOLLOWING:
		back to an exit.
and vapors.

8