![](/images/new-backgrounds/1059659/5965915x1.webp)
4.■ If using the rear electrical knockout, drill a 1¹⁄₄" (3.0 cm) dia. hole through the wall at the location shown.
hood support | centerline |
|
|
|
|
|
|
|
|
| ||
(front view) |
| A |
|
|
|
|
|
|
| |||
of hood |
|
|
|
|
| |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 2" | (5.1 cm) | |||||||
|
|
|
|
|
|
| ||||||
| Hood size |
|
| A |
|
| ||||||
| 36" (91.4 cm) | 14³⁄₁₆" (36.0 cm) |
| |||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
■If using the top electrical knockout, drill a 1¹⁄₄" (3.0 cm) dia. hole through the hood support at the location shown.
hood support | 2" (5.1 cm) | |
(top view) | ||
|
right rear hood mounting hole
1¹⁄₂"
(3.8 cm)
5.Remove the filters. Use two hands to remove filter. Push tab back to release the locking pin, pull down and forward. Set filter aside. Repeat with other filter(s).
6.Remove the terminal box cover located behind the right hand filter.
7.Install UL- or
Make Electrical Connection
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1.Disconnect power.
2.Run power supply cable to the hood electrical hole according to the National Electrical Code or CSA Standards and local codes and ordinances. There must be enough power supply cable from the fused disconnect (or circuit breaker) box to make the connection in the hood’s electrical terminal box.
3.Remove the four mounting screws from the parts bag. It is recommended they be placed by the holes in the hood liner support for quick access.
WARNING
Excessive Weight Hazard
Use two or more people to move and install range hood. Failure to do so can result in back or other injury.
4.Using 2 or more people, feed the wiring through the strain relief while lifting the hood liner into place.
5.Insert the screws through the support and thread into the hood liner holes. Tighten screws securely.
8