Refrigerator
Side Trim
3/8"
(9.7 mm)
1/16" 
(1.5 mm)
1/8"
(3.2 mm) 
Overlay
233/8"
(59.40 cm)
3/16"
(4.5 mm)
Recessed Inset Installation Dimensions
1.Measure the distance from point A (as shown) to back wall.
2.Route the front edge of the support board or attach a ³⁄₈" (9.5 mm) board to hold the panel in the cabinet side trim.
A
INSTALLATION
REQUIREMENTS
Tools and Parts
IMPORTANT:
■Installer: Leave Installation Instructions with the homeowner.
■Homeowner: Keep Installation Instructions for future reference. Save these Installation Instructions for the local electrical inspector’s use.
TOOLS NEEDED:
Make sure that you have the tools necessary for proper installation:
■ Hand drill or electric drill | ■ T27 | ||
| (properly grounded) |
| driver |
■ | Drill bits | ■ | ¹¹⁄₃₂" nut driver |
■ | Two adjustable wrenches | ■ | ³⁄₈" and ¹⁄₂" |
|
|
| wrenches |
■ | Phillips screwdriver | ■ | ⁵⁄₃₂" Allen wrench |
Inset Installation Dimensions
1.Measure the distance from point A (as shown) to the back wall. Add ¹⁄₃₂" (0.8 mm) to this measurement to allow the side panel to fit into the trim.
2.If the panel is more than ³⁄₈" (9.5 mm) thick, route the front edge to allow the side panel to fit into the trim.
A
■ | Small level | ■ | ⁵⁄₁₆" socket wrench |
■ | Appliance dolly | ■ | Tape measure |
PARTS NEEDED:
■Six #8 x 3" (7.6 cm) wood screws (longer screws may be needed)
■One or two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) wood board(s)
■Order factory panels, make custom panels or consult a qualified cabinetmaker or carpenter to make the panels.
Classic Series: Order factory panels, make custom panels, or consult a qualified cabinetmaker or carpenter to make the panels. See “Design Specifications” for more information.
Overlay Series: Make custom panels, or consult a qualified cabinetmaker or carpenter to make the panels. See “Installation Requirements” and “Design Specifications” for more information.
Pro Line™, Complete and Architect® Series are shipped complete.
■If you are connecting the water line directly to copper tubing and not to a shutoff valve, you need a ferrule, a union, and a ¹⁄₄" (6.35 mm) compression fitting.
15
