6.Remove the protective skin from the screw covers. Snap the screw covers into the handle trim section.
Top Grille Panel
1.Grasp both ends of the top grille.
2.Push straight up, then pull straight out. Place the top grille
BAB
A. Top grille
B. Cabinet side trim
3.Remove one end cap by loosening the nuts and sliding the end cap off.
A |
|
C |
|
B |
|
D |
|
A. Bottom rail | C. End cap |
B. Nuts | D. Top rail |
4.Slide the decorative panel into the top grille channel and reattach the end cap.
A
A. Backer panel
5.Replace the top grille in the cabinet side trims and pull the panel down slightly to lock it into place.
BAB
A. Top grille
B. Cabinet side trim
Level Refrigerator
NOTE: Classic and Overlay Series door panels must be installed before leveling.
1.Open the doors and place the level on top of the refrigerator frame as shown. Check to see whether the refrigerator is level from left to right.
A |
B |
B |
A. Level to check left to right leveling
B. Level to check front to back leveling
2.Use the leveling bolts to adjust the leveling legs until the refrigerator is level from left to right.
A | A |
B | B |
A. Rear leveling bolt
B. Front leveling bolt
3.Place the level(s) on shelf or shelves as shown. Check to see whether the refrigerator is level from front to back.
4.Use the leveling bolts to adjust the leveling legs until the refrigerator is level from front to back.
5.Be sure that all 4 leveling legs contact the floor and support the full weight of the refrigerator.
6.Make final check to ensure the refrigerator is level.
22
