ml Remove two nuts from one end of the top panel
n frame. Remove end piece. Slide decorative panel into panel frame. Replace end piece using nuts.
112IAttach the brace to the top right front comer of
. I the refrigerator cabinet with one screw. insert top grille flange into cabinet trim channel and align grille with top and side trim. Attach top grille mounting panel assembly to
-brace with one screw. Fasten grille in place with six screws.
Check that the power switch is in the “ON”position. Attach top grille decora- tive panel assembly to the keyhole bracket on the frame and pull down to secure. if the top grille decorative panel does not tit evenly within frame, the keyhole bracket can be moved side to side by adjusting the bracket screws or the decorative panel bracket can be moved up or down by adjusting the decorator panel bracket nuts.
Personal injury Hazard
Reinstall set screws after door swing is set.
Failure to so could result in personal injury.
lIzI Check that doors can open freely. if not, the
W door stops or hinges can be adjusted.
To adjust horizontally: Loosen set screw in top and bottom hinges with Allen wrench. Determine the door swing desired. Hold door in that position and tighten the set screws. The doors have stops at 90°, 115” and 137” positions. if the door stops cannot be adjusted to clear countertops, the countertops may need to be mitered. (Consult your builder to adjust countertops.)
To adjust vertically: Loosen, do not remove, top and bottom hinge screws. Lift door and bottom hinge to desired position. Tighten bottom hinge screws and then top hinge screws.
114Check the water I connections at the
bottom of the refrigerator
again for leaking. Any leaking can cause refrigerator and floor damage.
1151Open both doors. Use two screws to attach
W bottom grille to cabinet.
El Put shelves and bins into the refrigerator and
. freezer compartments. Remove protective film from door frame.
11718Move the ice maker arm into the down position.
Set refrigerator and freezer compartment controls to the midpoint between “COLD”and “COLDEST”. Check that the compressor is operating properly. Check that ail five interior lights and one exterior light above dispenser area are working.
118Use.1a drinking glass to press ice dispenser bar. You should hear the
motor and auger operating. Press the glass against the water dispenser bar. Dispense and discard about 2 to 3 quarts of water to remove air from system and rinse tank.
To get the most efficient use, from your new
Page 11
