Product support
A solid soffit or a wood block is required to prevent the refrigerator from tipping forward after it is installed.
Determine what height the refrigerator will be when it is installed to fit opening. Determine the height to the top of the cover at the final installed height you plan to use.
Personal Injury/Property Damage Hazard
::2ip
block(s)
Block(s) must extend to fully cover wldfh of cover.
important: Block(s) must extend al least 2” over cover.
l Unit is
lA solid soff it or 2” wood block is required above the refrigerator to prevent tipping during use.
l if solid soffrt is more than 1 inch above refrigerator, a wood block must be installed on the wail not more than
l/4 inch above the refrigerator cover.
Failure to follow these instructions could result in personal injury or property damage.
Your installation location may vary from the examples shown. However, you must support the refrigerator with a wood block or other adequate means of support located l/4” above the cover.
sotnt -
(more | than 1” |
|
| soffit- | ||
|
|
|
| |||
sbve | cQver)! | ,wood | block(s) | (less | than 1” | |
k |
|
| above | cover) | ||
|
|
|
| |||
|
| 114” | max. | 4 | - cover | |
|
|
| ||||
|
|
|
|
| ||
|
| cover |
|
| ||
|
|
| c |
| ||
Locate
1 above cover.
rear wail
\ rear wail
wail
When a sofflt is not available, locate wail studs in the refrigerator opening. Center one wood block and use wood screws to attach the wood block to the wail studs. Make sure screws engage wail studs a minimum of
Page 8
if soffit Is more than one inch above cover, locate wail studs in the refrigerator opening. Center one wood block and use wood screws to attach the wood block to the wail studs. Make sure screws engage wail studs a minimum of
of the first block. The wood block(s) must extend 2 inches beyond the ends of the cover.
If sofflt is less than one inch above cover, a wood support is not needed.
