15

Custom panel dimensions - Dishwashers

with control panel on the front

(65.8 cm)
(19.1 mm)
This dimension is for 4" (10.2 cm) toe kick. If the
installation needs a higher toe kick, adjust the height
of the wood panel accordingly. Not recommended for
toe kicks greater than 6" (15.2 cm).
*
(3.2 mm)
(Models KUDS40FVPA, KUDS50FVPA, KUDE60FVPA,
and KUDE70FVPA)
NOTE:The handle for the custom panel is not included.
IMPORTANT: If the handle is attached from the back of
the custom panel, the screw holes should be countersunk
for the screws heads to be flush with the panel. If the
handle is attached to the front of the custom panel, the
screw lengths cannot exceed the panel thickness. For
more information on KitchenAid custom handle
selection, refer to the KitchenAid Catalog, visit
www.kitchenaid.com, or call 1-800-422-1230.
NOTE: A customer-supplied full-front panel must weigh
no more than 16 lbs (7.3 kg) and must be made to
specific dimensions. It is recommended that a
cabinetmaker cut the custom panel because of the
precise dimensions needed.
NOTE: All mounting hardware supplied is for a ³⁄₄"
(19.1 mm) thick wood panel. If a thinner wood panel, or
materials other than wood are used, it is the consumer’s
responsibility to obtain the proper length screws and
adjust the pilot holes accordingly.
IMPORTANT: Use a moisture-resistant sealer on both
sides and all edges of the panel to avoid damage from
humidity.

Custom panel installation -

Dishwashers with control

panel on the top

This dimension is for 4" (10.2 cm) toe kick. If the
installation needs a higher toe kick, adjust the height
of the wood panel accordingly. Not recommended for
toe kicks greater than 6" (15.2 cm).
*
1
23¹⁄₂"
(59.7 cm) *30³⁄₁₆" (76.7 cm)
³⁄₄" (19.1 mm)
Gently set outer panel aside. Lay the customer-supplied
custom panel face down on a covered, non-scratching
surface.

Custom panel dimensions—

Dishwashers with control panel

on the top

2
outer panel
3 screws
per side
Install Custom Panel – Option 1
With a TORX®screwdriver, remove three screws from both
sides, as shown; hold the outer panel up while removing
the screws. Save screws for reinstallation.
Follow directions in Option 2 of “Install custom panel”
section.