28
To Replace:
1. Using 2 or more people, lift the oven door and insert both
hanger arms into the door.
2. Open the oven door.
You should hear a “click” as the door is set into place.
3. Move the hinge levers back to the locked position. Check
that the door is free to open and close. If it is not, repeat the
removal and installation procedures.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.

Nothing will operate

■Has a household fuse blown, or has a circuit breaker
tripped?
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.

Surface burners will not operate

■Is this the first time the surface burners have been used?
Turn on any one of the surface burner knobs to release air
from the gas lines.
■Is the control knob set correctly?
Push in knob before turning to a setting.
■Are the burner ports clogged?
On sealed burner models, see “Sealed Surface Burners”
section.

Surface burner flames are uneven, yellow and/or noisy

■Are the burner ports clogged?
On sealed burner models, see “Sealed Surface Burners”
section.
■On models with caps, are the burner caps positioned
properly?
See “Sealed Surface Burners” section.
■Is propane gas being used?
The range may have been converted improperly. Contact a
trained repair specialist.

Surface burner makes popping noises

■Is the burner wet?
Let it dry.

Burner sparks but does not light

■Is there continuous sparking, but the burner does not
light?
Discontinue use of the surface burner and contact a service
technician.

Excessive heat around cookware on cooktop

■Is the cookware the proper size?
Use cookware about the same size as the surface cooking
area, element or surface burner. Cookware should not extend
more than ¹⁄₂" (1.3 cm) outside the cooking area.

Cooktop cooking results not what expected

■Is the proper cookware being used?
See “Cookware” section.
■Is the control knob set to the proper heat level?
See “Cooktop Controls” section.
■Is the range level?
The range must be level for the griddle to operate properly.
See the Installation Instructions for leveling instruc tions.

Oven will not operate

■Is the electronic oven control set correctly?
See “Electronic Oven Control” section.
■Has a delay start been set?
See “Timed/Delay Cooking” section.
■Is the Control Lock set?
See “Control Lock” section.
■Is the Sabbath Mode set?
See “Sabbath Mode” section.

Oven temperature too high or too low

■Does the oven temperature calibration need adjustment?
See “Oven Temperature Control” section.

Display shows messages

■Is the display showing a letter followed by a number?
Clear the display. See “Display(s)” section. If a letter followed
by a number reappears, call for service. See “Assistance or
Service” section.