Connect to Refrigerator

 

Parts Supplied:

 

¹⁄₄" to ¹⁄₄" (6.35 mm to 6.35 mm) male-to-male coupling

 

1"

7"

(2.54 cm)

 

(17.78 cm)

 

Plug in Refrigerator

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

1.Set control switch at top of cabinet to the OFF position.

2.Plug into a grounded 3 prong outlet.

NOTE: The flexible, codes approved water supply line can connect to the supply valve through the floor or through the side cabinets, as indicated by the gray boxes above.

1.Unplug the refrigerator or disconnect power.

2.Connect the 7 ft (2.13 m) flexible codes approved water tube to the water supply valve.

3.Flush the main water supply line to remove particles and air in the water line. Allow enough flow so that water becomes clear.

4.Tape the 7 ft (2.13 m) flexible codes approved water supply line to the floor, 7" (17.78 cm) from the left side of the refrigerator. Tape along the length of the tubing, which will allow it to pass beneath the refrigerator without interference.

NOTE: Allow a minimum of 26" (66.04 cm) of flexible codes approved water supply line to be loose at the front of the refrigerator for connecting to the refrigerator.

5.Connect the 7 ft (2.13 m) flexible codes approved water supply line to the refrigerator.

NOTE: If the main water shutoff valve is behind the refrigerator, a secondary water shutoff valve may be installed in line with the water supply line at the front of the product.

Move Refrigerator to Final Location

WARNING

Tip Over Hazard

Refrigerator is top heavy and tips easily when not completely installed.

Keep doors taped closed until refrigerator is completely installed.

Use two or more people to move and install refrigerator.

Failure to do so can result in death or serious injury.

IMPORTANT: To avoid floor damage, make sure levelers are raised (not touching floor) and refrigerator is on rollers before moving.

C

B

A

D

E

F G

1.Place top of cardboard carton or plywood under refrigerator. Remove dolly.

2.Do not remove film or cover.

3.Move the refrigerator straight back and evenly into the opening. Be sure that the refrigerator side trims are not interfering with the door opening. Also, be sure that the water tubing is not kinked and the power supply cord is on top of the refrigerator.

A. Household water line

E. Bulb

B. Nut (purchased)

F. Nut

C. Ferrule (purchased)

G. Refrigerator water tubing

D.Coupling

6.Turn on the water supply valve and check all connections for leaks.

22

Page 22
Image 22
KitchenAid W10379133A Plug in Refrigerator, Move Refrigerator to Final Location, Parts Supplied, Connect to Refrigerator