KitchenAid W10379133A manual Install Overlay Series Custom Panels, Door Panel Installation

5.Replace the door handles. Install the top screw on each handle first. Be sure that the top of both door handles are aligned.

6.If the door handles are not aligned, loosen all handle screws and adjust door handles up or down. Tighten the screws.

7.Check refrigerator level and adjustment. Adjust if needed.

Top Grille Panel

1.Grasp both ends of the top grille.

2.Push straight up, then pull straight out. Place the top grille panel-side down on a soft working surface.

BAB

Install Overlay Series Custom Panels

IMPORTANT:

■Install the custom handles prior to installing the panels on the refrigerator. For more information on KitchenAid custom handle selection, refer to the KitchenAid Catalog, visit www.kitchenaid.com, or call 1-800-442-9991. In Canada, visit www.KitchenAid.ca, or call 1-800-807-6777.

■Create custom door overlay panels according to the specifications in the “Overlay Series Custom Panels” section.

■KitchenAid is not responsible for the removal or addition of molding or decorative panels that would not allow access to the refrigerator for service.

A. Top grille

B. Cabinet side trim

3.Remove one end cap by loosening the nuts and sliding off the end cap.

	A
C	B
D
A. Bottom rail	C. End cap
B. Nuts	D. Top rail

4.Slide the backer panel into the top grille channel and reattach the end cap.

A

A. Backer panel

5.Replace the top grille in the cabinet side trims and pull the panel down slightly to lock it into place.

BAB

A. Top grille

B. Cabinet side trim

Door Panel Installation

1.Remove all tape and door bracing from the refrigerator and freezer doors.

2.Open the refrigerator and freezer compartment doors.

3.Remove the handle-side and top trims.

AA

A.Trims

4.Slide the custom panels into the bottom and hinge side trims on the refrigerator compartment and freezer compartment doors, making sure that the backer panel fits into the hinge side trims.

AA

A. Panels

24