THANK YOU FOR USING THIS KLARK TEKNIK PRODUCT
To obtain maximum performance from this precision electronic product, please study these instructions carefully. Installation and operating the equaliser is not complicated, but the flexibility provided by its operating features merits familiarisation with its controls and connections. This unit has been prepared to comply with the power supply requirements that exist in your location.
Precautions
Before connecting the unit to the mains power, ensure that the operating voltage is correct for your local supply.
It is important that you observe the following instructions if another voltage setting is required.
Do not install this unit in a location subjected to excessive heat, dust or mechanical vibrations.
Voltage Selection and Power Connection
Connection is made by means of an IEC standard power socket. The rear panel voltage label, indicates the voltage required for satisfactory operation of the unit.
Before connecting this unit to the mains supply, ensure the fuse fitted is the correct type and rating is as indicated on the rear panel, adjacent to the fuse holder.
*Mains voltage change should be carried out by a qualified service technician only.
Safety Warning
This unit is fitted with
Signal 0V is referenced internally to chassis via a resistor capacitor network which provides earth loop immunity.
To prevent shock or fire hazard, do not expose the unit to rain or moisture. To avoid electrical shock do not remove covers. Refer servicing to qualified personnel only.
Attention!
Cables:
This product should only be used with high quality, screened twisted pair audio cables, terminated with metal bodied
Electric Fields:
Should this product be used in an electromagnetic field that is amplitude modulated by an audio frequency signal (20Hz to 20kHz), the signal to noise ratio may be degraded. Degradation of up to 60dB at a frequency corresponding to the modulation signal may be experienced under extreme conditions (3V/m, 90% modulation).