Klipsch THX ULTRA2 Remote Control, 3 4 UP/DOWN, 5 6 LEFT/RIGHT, Vol +, 910 CH +, 12MUTE, 13OK

THX SURROUND PREAMPLIFIER

STAGE ONE

REMOTE CONTROL

The supplied Philips ProntoNEO® touchscreen remote control is pre-config- ured for the Stage One. This programmable learning remote is enormously flexible and can be customized to operate your entire audio/video system. The remote has its own manual, which explains its operation in full detail. Be sure to read the ProntoNEO manual as well as the descriptions below to get the most from the remote control. The functions listed below apply only when the Stage One is selected on the remote control.

3 4 UP/DOWN

When in the menu system, the Up and Down buttons move between menu items. In the Speaker Configuration, Level Setting, and Speaker Distances menus, the Up and Down buttons change the channel selected for adjustment. When the Stage One is in Normal mode and decoding surround sound, the Up and Down buttons adjust the front/rear balance.

5 6 LEFT/RIGHT

Once you have selected a menu item, use the Left and Right buttons to adjust the value of its setting. When the Stage One is in Normal mode and playing a stereo signal, press the Left and Right buttons to adjust the left/right balance.

18

16

17

3

14 1 2 15

79

56

13

8	4	10
12		11

78 VOL +/–

The Vol+ and Vol– buttons adjust the Stage One’s overall volume level.

910 CH +/–

When the Stage One’s built-in tuner is selected, the CH+ and CH– but- tons seek forward and back to the next station with enough signal strength for clean reception.

11ƒ

Pressing the F button brings the remote back to the input selection page.

12MUTE

The Mute button toggles the Stage One’s audio output on and off. When you are adjusting the Level Settings in the Setup menu, pressing the Mute button will exit the menu without saving changes.

13OK

Press the OK button to enter and exit menus.

14MODE

Holding down the Mode button brings up the remote control’s setup menu, which allows you to program the remote. For detailed instructions on how to use this function, see the ProntoNEO manual.

HARD BUTTONS

1ADJUST

The Adjust button switches the remote control touchscreen to the Adjustments page, which has buttons for jumping to the most commonly used mode and system adjustment pages.

2SETUP

The Setup button switches the remote control to the Setup page, where you can enter the system setup functions.

15DEVICE

Pressing the Device button brings up the top-level Device page, which is where you select which component you want the remote to address. Select the Stage One by pressing the Stage One button at the bottom of the page.

16 17 PAGE UP/DOWN

On the left hand side of the remote, the Page Up and Down buttons enable you to scroll through the pages that apply to the currently select- ed device.

18BACKLIGHT

Pressing the Backlight button lights up the touchscreen and hard buttons so you can see them clearly in the dark. To adjust the touchscreen’s con- trast, press the Page Up and Down buttons while holding down the Backlight button.

12