Ductwork Installation
7.Use 8” aluminum or steel pipe (follow building codes in your area) to connect the ducting transition on the hood to the ductwork above. Use duct tape to seal and secure joints as shown in Figure 5.
Wiring to Power Supply
S A F E T Y W A R N I N G
TO PREVENT THE RISK OF ELECTRICAL SHOCK OR INJURY, ALL RANGE HOODS SHOULD BE PROPERLY GROUNDED AND INSTALLED BY A TRAINED PROFESSIONAL WHO IS KNOWLEDGEABLE ABOUT APPLICABLE NATIONAL AND LOCAL ELECTRICAL CODES.
BEFORE CONNECTING WIRES, SWITCH POWER OFF AT SERVICE PANEL TO PREVENT POWER FROM BEING SWITCHED ON ACCIDENTALLY.
8.Connect electrical wires.
-Connect three wires (black, white and green) to house wires and cap with wire connectors. Connect wires according to their colors (i.e. black to black, white to white, and green to green). See Figure 6.
-Prevent wires from slipping between motor and any moving parts by securing in electrical box.
Final Assembly
CAUTION: Install heating lamps last.
9.Drop Oil Tunnel into support structure. Refer to Figure 7.
10.Angle baffle filter toward back of hood . Refer to Figure 8.
11.Push baffle filter up until almost level.
12.Slide forward into recess at front of hood.
13.Lower baffle filter and slide back until it fits into resting position .
14.Repeat for all baffle filters and spacers. Refer to Measurements and Diagrams on page 21 for baffle filter and stainless spacer arrangement.
7
Figure 5
Figure 6
Figure 7
