all joints secure and air tight as shownFigureon 16 Figure 14.
7.To convert ductwork to 7 round, attached
7 round adapter (provided) to the 6 round plastic exhaust.
8.Slide the inner duct cover up 2 inches before sliding the entire duct cover onto the hood. Refer to Figure 15.
9.Adjust the height of the inner duct cover to the duct
10.Fasten outer duct cover to plastic plate on
the hood with four (4x8 mm) screwsFigure 17 (provided) as shown in Figure 16.
Accessories
11.Attach oil tunnel. Refer to Figure 17.
12.Refer to Figure 18.Slide the baffle filter into the hoodPush. the baffle filter upward. Slide forward. Pull downward. Fit into place.
13.For bottom casing, repeat above steps. Refer to page 15.
Final Assembly
Figure 18
14.Turn power ON in control panel. Check all lights and fan operation.
15.Make sure to leave this manual for the homeowner.
10