JVC HR-VP646U manual On-Screen Timer Programming, Access ON-SCREEN, Menu, Access Program SET

40ENTIMERRECORDING(cont.)

On-Screen

Timer

Programming

Turn on the TV and select the VCR channel 3 or 4 (or AV mode).

2 2

q 5/8 6

MENU CH OK

1 2 3

4 5 6 NUMBER

7 8 9

NUMBER "9"

		0
NUMBER	"8"	CH
1	3	Á
¦	7	8

4¢

MENU	SHUTTLE PLUS
OK

You can directly program the VCR’s timer to record up to 8 shows, as far as a year in advance. Remember, the clock must be set before you can program the timer (☞ pg. 7 or 9).

1	LOAD A CASSETTE
	Make sure the record safety tab is intact. If not, cover
	the hole with adhesive tape, then load.
	● The VCR comes on, and the counter is reset,
	automatically.

		ACCESS ON-SCREEN
2		MENU
		Press MENU as many times as necessary to bring up the
		Main Menu screen.
		ACCESS PROGRAM SET
3		SCREEN
		Make sure the highlight bar (arrow) is on "PROGRAM
		SET", then press OK.
4		SELECT PROGRAM NUMBER
		Press the appropriate
				PROGRAM 1
		NUMBER keys or CH5°or
		SHUTTLE PLUS %Þto	DATE		– –/– –
			START		– –:– – AM
		select a vacant program	STOP		– –:– – AM
		number, then press OK. The
			CHANNEL		– – SP
		first time you set the timer
		programming function, all	PRESS NUMBER KEY (O–9)
		the program numbers will	OR (5,°), THEN (OK)
			PRESS (MENU) TO END
		be blank; in this case just
		press OK when the Program Set screen appears.
		SET PROGRAM
5		INFORMATION
		Press the appropriate NUMBER keys to set the date,
	start/stop time and channel number. Press CH5° or
	SHUTTLE PLUS %Þ to set AM/PM and tape speed (SP
	or EP). Press OK after AM/PM, channel number and
	tape speed settings.

* If you are using a DBS receiver, see "ATTENTION FOR

DBS RECEIVER USERS" on next page.

● Any information comprised of 1 digit (except the

channel number) should have a "0" entered before it.

● It is possible to set all information using the CH5° or

SHUTTLE PLUS %Þ button.

(In this case, press OK after each setting.) Do not use

the CH ° or SHUTTLE PLUS Þ button to set the date.

● At the Program Set screen, the setting that can be set

blinks. When setting of a highlighted item is completed,

the highlight bar moves down by 1 line to the next item.

** You can record selected programs at the same time

EXAMPLE

If you program the VCR to timer record a show on December 24 on channel 40 from 12:00 noon to 1:00 PM in SP mode, the screen will look like this:

PROGRAM 1

DATE	12/24	WED
START	12:00	PM
STOP	1:00	PM
CHANNEL	40	SP

PRESS NUMBER KEY (O–9) OR (5,°), THEN (OK)

PRESS (MENU) TO END

every weekday, or once a week. Before entering the

month, press NUMBER key “8” (DAILY) or “9”

(WEEKLY). Either "DAILY" or "WEEKLY" appears.

Press again and "DAILY" or "WEEKLY" disappears.

For weekly recording, the desired date for the day of

the week must be entered.