STAND ALONE INSTALLATION
***This installation only applies with the purchase of an optional duct cover (Mod
SAFETY WARNING
HOOD MAY HAVE VERY SHARP EDGES; PLEASE WEAR PROTECTIVE GLOVES IF IT IS NECESSARY TO REMOVE ANY PARTS FOR INSTALLING, CLEANING OR SERVICING.
Preparation before installation
-Temporarily wire the hood to test for proper operation before installing.
-Peel protective film off the hood and the duct cover (if any).
-If necessary, prepare back wall frame with cross framing lumber for secure i Using references on Table 2 and measurements on page 14, decide the level of lumber. Refer to Figure 5.
Hood Installation
CAUTION: If required to move the cooking range to install the hood, turn off the p electric range at the main electrical box. SHUT OFF THE GAS BEFORE MOVING A GAS RANGE.
1.Remove the five screws at the center of the hood top. Use the five screws to plastic plate onto the hood as shown in Figure 6. NOTE: Disregard the hole t plastic plate.
2.If necessary, attach two rubber stands (provided) withscrewstwo (4x8(provided)mm) to the back of the hood.
Figure 5
3.Attach the
4.Use the references on Table 2 and the measurements on page 14 to decide the le the hood. Position two mounting screws (not provided) on the wall, leaving 1/ from the wall. Refer to Figure 8.
7