Kodak 3020 instruction manual Technical Data, Mechanical System Illumination

Technical Data

Mechanical System			Illumination
Projector Measurements (see page 90):	Drive:		82V/35h/300W halogen lamp(s) with inte-
Length:340mm	1	stepper motor for tray motion	grated cold light reflecting mirror.
Width:336mm	1	stepper motor for slide lift and tray	EKTAPRO4020/5020/7020/9020:Modular
Height:140mm		release mechanism	automatic lamp change system. In case of
Height with tray: 175 mm	1	DC motor for focus	lamp failure the system automatically
Weight without tray: approx. 9000 g	1	DC motor for fan cooling	switches over to the second lamp (<0,3sec).
Weight of tray without slides: 540 g	1 DC motor for the mirror (automatic		LED indicators showing defective lamps.
		lamp changer)	• No adjustment necessary.
Slide Formats:	1	rotary solenoid for the shutter	• You can pull out the entire module out of
24x36mm			the projector to replace a defective lamp
4 x 4 (superslide) with special condenser	NoiseDevelopment:		• Choice of standard, economy or High
	approx. 57 dB (A)		Light setting for projection lamp.
Slide Trays:

KODAKEKTAPRO80SlideTrayforhold- ing 80 slides with a maximum slide mount thickness of 3.2 mm.

KODAK CAROUSEL TRANSVUE 140 Slide Tray for holding 140 slides with a maximum slide mount thickness of 1.2 mm.

SlideGate:

Gravity-feed slide change with register- gate pressure levers in two planes to ensure good slide alignment.

LensMount:

Universal lens mount for both spiral- and rack-mounted lenses (such as KODAK Projection FF Lenses).

Height Setting:

Height setting to a maximum of 10o via two turnable feet.

Levelling:

The projector may be operated at an angle of plus or minus 30o from the horizontal along the projector axis.

Note: Tilting the projector side ways will adversely affect the lamp lifetime!

Housing:

Sturdy,fibre-glassreinforcedhousing (LEX- AN).

All parts are marked and therefore fully recyclable.

All important structural elements for the optical equipment such as slide gate, lamp module and base for the lens mount hous- ing are in die-cast zinc assemblies.

ProjectionLamps (available as accessories): EXR82V/35h/300W Brightness 100%

FHS82V/70h300W Brightness 80% EXY82V/200h250W Brightness 60%

The economy setting reduces the lamp output to around 75% of the normal value (tripling bulb life).

The high light setting increases the lamp output by 20% (whilst reducing bulb life by 30%).

Temperature range for safe operation The operating temperature range of the projector depends on the ambient temper- ature and the voltage (see illustration). Standard and economy setting: Minimum0o Candmaximum+40o C High Light setting (models 7020/9020): Minimum0o Candmaximum+35o C

a= Ambient temperature (Co) b = Nominal voltage

a

40º 35º

30º

20º

10º

-10% b +6%

Should the projector overheat, e.g., due to lack of cooling air, the built-in thermal cut- out automatically switches the lamp off and then switches it on again once it has cooled down.

36