Switching-on the projector
Check voltage setting
EKTAPRO Slide Projectors will be exported throughout the world to countries with differing mains voltages. The projectors are already set during manufacture to a fixed mains voltage.
Shipments to countries with 100 or 120 V mains will be equipped with a 4 A slow blow/ 250 V fuse. A spare fuse for replacement is also supplied.
Shipments to countries with 220, 230 or 240 V mains will be equipped with a T 2A L/ 250 V fuse. A spare fuse for replacement is also supplied.
Before you switch on your projector ensure that the voltage is correctly adjusted! An incorrectly adjusted mains voltage can damage the projector! The voltage indicator (30) must show your country´s actual mains voltage!
2.
1.
3.
Setting of a different operation voltage
WARNING
For safety, the mains lead must be unplugged!
Important:
Ensure that the 100 and 120 V setting uses a different fuse to the 220
1. Unlock the fuse link compartment (31) by using a screwdriver and pull compartment out.
2. Push the fuse link (32) into the compartment so -
3. - that the applied voltage can be seen in the window (30) of the compartment.
.Push the loaded compartment (with mounting underneath) firmly into the projector opening provided.
Switching- on the projector
.Connect your EKTAPRO Slide Projector to themains withthemainslead. (UK users note: A suitable fused 13A plug must be
.fitted. See instructions on cable!) Turn on the mains switch (34).
The projector is switched on and ready for use.TheredLED(18)ison;lampandfanare switched off. I.e. the projector stays in a "silent" mode. With any strike on a key (such as transport, standby, ..) lamp and fan will be switched on.
Note:
If a problem on the slide change is detected, the red LED (18) (operation indicator) will start to blink and the projector can no longer be operated (see Trouble Shooting Guide, page 34).
Tray setting
1
40
80
10
Round trays for both 80 slides and 140 slides can be used. The tray setting switch
(10)is set in the factory to accomodate the 80 tray. By using a small screwdriver, the switch can be brought into the 140 position.
Caution
If the projector is not properly adjusted, there will be transport problems!
You can only set the EKTAPRO 3020 before you switch on the projector!
24
