Kodak CIS-201 specifications

b.Type MOPC (Modify Paper Channel). Enter the Paper Channel that you copied to in Step 3a.

c.Change the Paper Type to the Paper Number of the new paper defined in Step 2.

d.Save the changes. (Enter Y when VALUES OK? appears.)

4.Create a Film Channel.

a.Copy your current Film Channel to an unused Film Channel (use the COFC command). Enter the source channel and destination channel. Save the changes. (Enter Y when VALUES OK? appears.)

b.Type MOFC (Modify Film Channel). Enter the Film Channel that you copied to in Step 4a.

c.Change the Brand/Paper Type to the code number of the new table created in Step 1.

d.Adjust the balance 0.000, 0.010, -0.040 to compensate for the Agfa MSP densitometer.

e.Save the changes. (Enter Y when VALUES OK? appears.)

5.Balance the paper.

a.Load a roll of EKTACOLOR Edge 8/ROYAL VIII Paper into a magazine and install it in the printer.

b.Load the Paper Channel from Step 2 and the Film Channel from Step 3, using the LOAD command.

c.Expose a test print by using the ETP (Expose Test Print) command. Process the test print. Use the ACC (Automatic Channel Calibration) command and insert the test print when prompted. Allow the recommended Paper Channel changes. Make another test print and continue this step until no changes are needed.

d.The balanced test print will appear cyan-green, and will be approximately +0.12 cyan and –0.03 green from neutral Status A. The Film Channel balance change compensates for this bias.

e.Run a reel of test negatives to confirm that the new paper has been correctly installed.

AGFA-Recommended Schwarzchild Coefficients for KODAK EKTACOLOR Edge 8/ROYAL VIII Papers

					MSP / MSC					MSCs Without				MSCs With
											Loqik 4			Loqik 4
		Blue			Green		Red		Blue		Green	Red	Blue	Green	Red
25ms	0.016				0.001		0.008
50ms	0.006				-0.002		0.002
100ms	0.000				0.000		0.000		13		-9	-1	13	-9	-1
200ms	-0.008				0.004		0.001		5		-6	0	5	-6	0
400ms	-0.013				0.009		0.001		0		0	0	0	0	0
800ms	-0.016				0.016		0.002		-3		6	1	-3	6	1
1600ms	-0.016				0.022		0.004		-3		13	3	-3	13	3
3200ms	-0.021				0.032		0.005		-7		23	4	-7	23	4
Gamma 1/2/3	1.8				2.4		2.7		1.8		2.4	2.7	1.8	2.4	2.7
AGFA Recommendations for Printing on KODAK EKTACOLOR Edge 8/ROYAL VIII Papers
	Type Measuring Filter for
MSP			MSC/PSP8				MSC 101
7660/261				8501/147			8506/213
	MASK Value—MSP Only
		(Command MOTC)
		Blue				Green		Red
Mask		0.901				0.720		0.340
Under		1.322				1.060		0.718
Normal		1.778				1.435		1.128
Over		2.623				2.201		1.913

Printer Conversion to KODAK EKTACOLOR Edge 8 and EKTACOLOR ROYAL VIII Papers • CIS-201 9