Service
Random access operation
Any slide can be selected using the KODAK EKTAPRO IR Remote System (available as accessory, see page 22). Ac- cess is fast, within approx. 5 sec: Input the required slide number to your IR remote control and confirm using <*>.
The RA operation is ideal for lectures, inter- active learning programmes and computer control. For further details, please see the instructions manual for the IR EKTAPRO Remote System RA and EKTAPRO IR Re- mote System RA/LP.
Operationviatimer
ItisnotallowedtooperatetheKODAK EKTAPRO320SlideProjectorwithan externaltimer!
Simultaneous Projection
1.With the KODAK EKTAPRO Twin Socket Adapter (accessory)
You can connect two projectors in parallel using the Twin Socket Adapter and an EKTAPRO Twin Socket Connecting cable (accessory). The adapter is inserted into the remote control socket (4). The cable connects the Twin Socket Adapter with the remote control socket of the second projec- tor (see illustration).
You control the projectors with the cable remote control as shown in the drawing. The connection of the IR receiver is also possible. However, this can only be con- nected to the receiver with the 8 m extension cable (accessory).
2.Using the KODAK EKTAPRO IR Re- mote Systems
Several EKTAPRO Projectors can be op- erated simultaneously when each projector is equipped with an EKTAPRO IR Receiver
(available as accessory, see page 22).
This mode should only be used for slide change purposes! The focus operation will occur on all projectors in parallel! Ensure that all receivers and the transmitter are set to the same channel!
Note:
Simultaneous Projection with other EKTAPRO models
If transport buttons are held down longer than a second the trays may stop at differ- ent positions due to different slide change times
Replacement of fuses
WARNING:
Always switch off the projector and unplug the mains lead before replacing a fuse!
Avoid the risk of fire, replace only with a fuse of same type and rating!
Replacement of primary circuit fuse
1. Pull out the fuse link compartment (11). Do not change the position of the fuse holder when reinserting into the projector (see also page 16).
.Replace the defective fuse (14) (tech- nical data, page 23).
.Push the fuse link compartment back into the projector.
1.
20
