Troubleshooting
41
Picture quality problemsSlide Show does not
run on an external
video device
■Adjust the camera Video Out setting (NTSC or PAL,
page20).
■Make sure the external device settings are correct
(see the device’s user’s guide).
If... Try one or more of the following
The picture is too dark
or underexposed
■Use Fill flash (page14) or change your position so light is
not behind the subject.
■Move so that the distance between you and the subject is
within the effective flash range (see page14).
■To automatically set exposure and focus, press the Shutter
button halfway and hold. When the ready light glows
green, press the Shutter button completely down to
take the picture.
■Increase Exposure Compensation (page16) and try again.
The picture is too light ■Turn flash off (page 14).
■Move so that the distance between you and the subject is
within the effective flash range (see page14).
■To automatically set exposure and focus, press the Shutter
button halfway and hold. When the ready light glows
green, press the Shutter button completely down to
take the picture.
■Decrease Exposure Compensation (page16)
and try again.
■Check if you are in Beach or Snow scene mode (page10).
The picture is not clear ■To automatically set exposure and focus, press the Shutter
button halfway and hold. When the ready light glows
green, gently press the Shutter button completely down
to take the picture.
■Clean the lens (page49).
■Make sure camera is not in Close-up mode if you are
further than 39 in. (100 cm) from your subject.
■Place the camera on a flat, steady surface or use a tripod.
If... Try one or more of the following