Troubleshooting
www.kodak.com/go/support 51
Camera/computer communicationsLCD messagesReady light glows
steady red.
■Transfer pictures to the computer (see page44), delete pictures from
the camera (see page 15), switch image storage locations (see
page 30), or insert a card with available memory (see page3).
■Wait. Resume picture taking when the light turns off.
■Change the image storage location to internal memory (see page30),
or use a different card.
Ready light is off or
glows steady
green.
■Camera is operating normally.
If Try one or more of the following
The computer does
not communicate
with the camera.
■Turn on the camera (see page2).
■Install new batteries (see page 1) or charge rechargeable batteries.
■Connect cable to camera and computer port (see page44).
■Install the software (see page 43).
■Disconnect the USB cable. Close all open applications. Re-install the
software (see page43).
■Disconnect camera from the computer. Close all software applications,
reconnect camera.
Cannot transfer
pictures.
(The Add New
Hardware Wizard
cannot locate
drivers.)
■Disconnect USB cable. (If using camera dock or printer dock,
disconnect cable and remove camera from dock). Close all open
applications. Re-install the software (see page 43).
■Disconnect the USB cable. Close all open applications. Re-install the
software (see page43).
If Try one or more of the following
No images to display ■Change image storage location setting (see page 30).
If Try one or more of the following