Troubleshooting

 

 

 

If

Try one or more of the following

 

In Review mode, a

Transfer the picture to the computer (see page 44), then format the

blue or black

card or internal memory (see page 33).

 

screen is displayed

Caution: Formatting a card deletes all pictures and videos,

 

instead of a

including protected files.

 

picture.

 

 

 

 

 

Shutter button

Turn on the camera (see page 2).

 

does not work.

Wait until the Ready light stops blinking red before attempting to take

 

 

another picture.

 

 

Transfer pictures to the computer (see page 44), delete pictures from

 

the camera (page 15), switch image storage locations (see page 30),

 

or insert a card with available memory (page 3).

 

 

 

 

Slide show does

Adjust the camera Video Out setting (NTSC or PAL, see page 32).

 

not run on external

See the external device’s user’s guide.

 

video device.

 

 

Picture is too light.

Move so there is at least 2 ft (0.6 m) between the camera and the

 

 

subject.

 

 

Decrease Exposure Compensation (see page 38).

 

 

 

 

Picture is not clear.

Clean the lens (see page 60).

 

 

Make sure your camera is not in Close-up mode.

 

 

Move so there is at least 2 ft (0.6 m) between the camera and the

 

 

subject.

 

 

Press the shutter button halfway to focus and set exposure. When the

 

ready light turns green, press the Shutter button completely down.

 

 

Place the camera on a flat, steady surface or use a tripod.

 

 

 

 

Picture is too dark.

Turn on the flash (see page 9).

 

 

Move so there is no more than 11.8 ft (3.6 m) in wide angle and

 

 

6.9 ft (2.1 m) in telephoto between the camera and the subject.

 

 

Use Fill flash (see page 9) or change your position so light is not

 

 

behind the subject.

 

 

Increase Exposure Compensation (see page 38).

 

 

 

 

www.kodak.com/go/support

49

Page 55
Image 55
Kodak Z1085 IS manual Troubleshooting