Kodak Z710 manual Direct printing PictBridge problems, Use P mode to adjust the Exposure

Troubleshooting

If	Try one or more of the following
Picture is too light	■ Reposition camera to reduce the amount of available light.
	■ Turn flash off (page 9).
	■ Move so that the distance between you and the subject is within the
	effective flash range (page 9).
	■ To automatically set exposure and focus, press the Shutter button
	halfway. When the AF/AE indicator turns green, press the Shutter
	button completely down to take the picture.
	■ Use P mode to adjust the Exposure.
Picture is not clear	■ To automatically set exposure and focus, press the Shutter button
	halfway. When the AF/AE indicator turns green, press the Shutter
	button completely down to take the picture.
	■ Clean the lens (page 58).
	■ Make sure camera is not in Close-up mode if you are more than
	27.6 in. (70 cm) from your subject.
	■ Place the camera on a flat, steady surface or use a tripod, especially
	in high-zoom settings or in low light.

Direct printing (PictBridge) problems

If	Try one or more of the following
Cannot locate desired picture.	■ Turn on the camera. Make sure the camera is not in
	Favorites mode.
	■ Use the Direct print menu to change the image
	storage location.
The Direct print menu interface	Press any button to redisplay the menu.
turns off.
Cannot print pictures.	■ Ensure that there is a connection between camera
	and printer (page 41).
	■ Ensure the printer and camera have power.

48 www.kodak.com/go/support