Kohler K-10104 manual Troubleshooting, Complete the Installation cont, Symptoms, Probable, Causes

Complete the Installation (cont.)

Place the handle in the vertical position, as shown.

Rotate the handle clockwise, then reposition the handle at the 2 o’clock position.

For hot and cold water supply installations: Rotate the handle as

needed to achieve the desired water temperature.

For tempered or filtered water installations: Turn the handle

counterclockwise to the full cold position.

Secure the cover and handle to the valve with two screws (provided).

7. Troubleshooting

Symptoms	Probable		Recommended Action
	Causes
1. No water	A.	There is a	A.	Remove the valve cover and
flow.		loose		check the connections from the
		connection.		battery to the solenoid and
				from the battery holder to the
				sensor. Make sure that the
				connector arrows are aligned
				and that the connection is
				secure.
	B.	The	B.	Confirm the supply stops are in
		supply		the ″ON″ position.
		stops are
		in the
		″OFF″
		position.
	C.	The	C. Remove the cover and inspect
		wires/cables		the wires/cables for cuts or
		are		damage. If the wires are cut or
		pinched or		damaged, order a new
		damaged.		solenoid, sensor assembly,
				sensor extension cable, or
				battery holder. Do not pinch or
				damage the wires during
				reassembly.

1056542-2-B 10 Kohler Co.