Faucet

O-Ring

 

Flexible Hose

 

Threaded

Bracket

Stud

 

Sensor Cable

Washer

Nut

Sink

1. Install the Faucet

NOTE: If possible, install the faucet to the sink before installing the sink.

Slide the O-ring over the flexible hose, sensor cable, and threaded stud. Position the O-ring into the groove in the base of the faucet.

Run the flexible hose, stud, and sensor cable through the mounting hole of the sink.

Slide the bracket, washer, and nut onto the threaded stud from underneath the sink.

Securely tighten the nut against the underside of the sink. Do not overtighten the nut.

Install the sink at this time. Refer to the sink manufacturer’s installation instructions.

2. Convert to Tempered or Filtered Water (Optional)

Remove the hot water supply hose from the valve body assembly with a wrench.

Cap the hot water supply inlet on the valve body assembly with a plug (provided). Wrench tighten the cap.

Turn the mixer valve on the valve body assembly to full cold.

1056542-2-B

4

Kohler Co.

Page 4
Image 4
Kohler K-10104, K-10103 manual Install the Faucet, Convert to Tempered or Filtered Water Optional