Install the Lavatory (cont.)
Immediately wipe away any excess sealant, and ®ll any voids as needed.
Verify that the lavatory has not moved out of position.
Allow the sealant to cure for at least 30 minutes before proceeding.
Connect and tighten the trap to the drain, and complete the water supply connections to the faucet according to the instructions packed with the faucet.
Run water into the lavatory and check for leaks.
Clean up with a
K-2273
Temporarily position the lavatory in the countertop cutout. Draw a pencil line around the lavatory edge where it touches the countertop. Remove the lavatory.
NOTE: Do not substitute another sealant for the one provided. The supplied sealant is required to permanently bond the lavatory to the countertop.
Apply 1/8² (3mm) beads of sealant to the countertop surface according to the illustration.
Set the lavatory into the countertop cutout. Use care to avoid smearing the sealant beads.
Immediately wipe away any excess sealant, and ®ll any voids as needed.
Verify that the lavatory has not moved out of position.
Allow the sealant to cure for at least 30 minutes before proceeding.
Connect and tighten the trap to the drain, and complete the water supply connections to the faucet according to the instructions packed with the faucet.
Run water into the lavatory and check for leaks.
Clean up with a
Kohler Co. | 5 |
