Kohler K-6227A important information, specification, Plumbing Connections, Applicable Standards

Tap

important information

Due to the non-standard diameter of the remote valve (51 mm), the remote valve cannot be installed through a standard 35 mm tap hole in a sink. Choose a sink without tap holes then install the tap and remote valve through the countertop. Refer to the countertop manufacturer for drilling of the holes.

1. Make sure that you follow all the local plumbing and building regulations in operation.

2.	For new installations, install the
	tap in the sink before installing
Remote Valve	the sink.

3.Before installation, unpack the tap and inspect for damage.

specification

Plumbing Connections

G ½” Compression Fitting

Hot (H) and Cold (C) inlets must be connected to the correct inlet supplies.

Applicable Standards

ASME A112.18.1-2005/CSA B125.1-05; AS/NZS 6400:2005; AS/NZS 3718:2005; AS/NZS 4020:2005

Recommended Operating Pressures: 140 to 860 kPa (20 to 125 psi).

Rated Operating Temperatures: 5° to 71° C (40° to 160° F).

Tested Hydrostatic Burst Pressure: 3450 kPa (500 psi).

1109784-A2-A

2