Kohler K-1172, K-7159, K-7158, K-700 Install The Bath, Setin, B Install Plumbing, Whirlpool

9.INSTALL THE BATH

A￿	WHIRLPOOL	SET￿IN
Corner or Recessed Installations:Move the
whirlpool into position.		Insert	the drain tailpiece into the
trap.	Level the whirlpool by fitting metal shims under
the	whirlpool feet, as needed.		The whirlpool must be
level	and resting on all four		feet. Check for level along
the	top of the whirlpool, and		across the drain side. If the Me￿￿l￿Shim￿

feet are not accessible from the back or side, move the whirlpool in and out of position until it is shimmed properly.

Me￿￿l￿Shim

Option For Sunken Installation: Set		the bath into the
sunken installation. Make sure the unit is level and
resting on all support feet. Insert		the drain tailpiece	into
the	trap. Apply a bead of silicone	sealant under the	rim
of	the unit.

B￿ INSTALL PLUMBING

CAUTION:(Risk of property damage￿ Ensure a watertight seal on the whirlpool drain connections.

1.Connect the drain to the trap according to the

drain manufacturer's instructions.

NOTE: An access panel will simplify future
maintenance.	C￿nne￿￿ He￿e

2.Install the faucet valving and spout tee. Open the hot and cold water valves, and check the supply connections for leaks.

3.Run water into the bath, and check the drain connections for leaks.

110050-2-AB 7 Kohler Co., Kohler WI U.S.A.