Kompernass KH 1282 Ironing with steam blast, Ironing with the spray function, Drip-Stop Function

IB_KH1282_E5554_UK_3 10.09.2007 16:20 Uhr Seite 8

Drip-Stop Function

This iron is fitted with a Drip-Stop function. It prevents the dripping of water from the ironing sole i when the iron is switched off and when steam ironing. When steam ironing, the iron must be set to at least level ••. Consequently, first set the steam controller s to "Steam" when the temperature control knob u is set to at least level •• and the temperature has been reached. Otherwise, water could leak from the ironing sole i.

Ironing with steam blast

The steam blast is especially suitable for smoothing difficult to reach parts of a garment.

Note: Steam-blast is first possible from level

•••.

•Slightly raise the steam iron.

•For one steam blast, press the steam blast button d once.

Ironing with the spray function

• To moisten the laundry, press the spray button

q.

This function is suitable for very dry and very crum- pled garments.

Temporarily setting the steam iron aside

Fire hazard!

Never leave the steam iron unattended when it is hot or switched on.

• Adjust the temperature controller u to "Min".

•Stand the steam iron on its back end t.

or

•Lay the steam iron in the support provided on the ironing board.

Important: NEVER place the steam iron on unsuitable surfaces. Risk of fire!

Taking the steam iron out of service

•Remove the power plug from the wall socket.

•Allow the steam iron to cool down.

•Drain the water tank y in that you open up the water fill opening o and either tip the contents out to the side (see Fig.1) or empty it by tipping it up to the front (see Fig.2).

✓

Fig.1
Fig.2	✓

•Clean the sole of the iron i (see chapter "Cleaning and care").

•Coil the power cable e around the power cable retainer at the back end of the iron t.

•Place the cooled down steam iron horizontally onto a soft and clean surface.

- 8 -