Aiphone FK1629 B 0811YZ System Setting Flow, Go to P, First select the, Start, paging, etc.?

SYSTEM SETTING FLOW

First of all, make the network settings. The network setting method differs according to the network environment. Select the flow suitable for your network environment from the chart below, and start the network settings after you fully understand it. After the network settings are finished, make the other individual system settings. See P. 15-28 for the system setting details.

NOTE:

The system settings should be made mainly on the IP host unit in the system (in a site). You select one as the IP host unit among the IP units connected to the system and others as the IP client units. (A PC master station (IS-SOFT) cannot be used as the IP host unit.)

First select the

Flow 1

,

Flow 2

or

Flow 3

from the chart below, then start the network settings by

following the selected flow.

START

Do you communicate with remote sites (calling, call transferring,

paging, etc.)?

YES

NO

NO(*4)

Do you use a router on which UPnP functions,

and does UPnP function normally?

(*1)

YES

Do you have a DHCP server (or router that

has a DHCP server function) in the network,

Do you have a DHCP server (or router that

NO(*3)

and does it have an automatic IP address-

has a DHCP server function) in the network,

assigning function?

and does it have an automatic IP address-

assigning function?

YES

NO

YES(*3)

(*2)

Flow 1

Flow 2

(IP host unit: A static IP address is set,

(All units: Static IP addresses are set)

IP client units: IP addresses are assigned by the DHCP

server automatically)

Go to P. 9.

Go to P. 10.

NOTE:

If you connect a PC master station (IS-SOFT) to the network, install the software (IS-SOFT) to a PC before connecting it to the network.

(*1): UPnP may not function normally depending on the router. Refer to [System log]→[UPnP operation check result] (→P. 29) on the IP host unit. If the [System log] window shows that UPnP is not functioning normally, the UPnP function of the router cannot be used with this system. In that case, set [UPnP] to OFF at [Network setting: Common] (→P. 16) and then make settings on the router again by confirming the settings at [IP unit registration] (→P. 19). See http://www.aiphone.net/ for the router to which the operartion check has finished and setting examples.

(*2): If the DHCP server (or router that has a DHCP server function) has a function to assign a static IP address to a specified MAC address, you can make the DHCP server assign the IP addresses to all the IP units automatically.

(→ Flow 3 (All units: IP addresses are assigned by the DHCP server automatically) (P. 11))

(*3): Set [UPnP] to ON at [Network setting: Common] (→P. 16) (Default: ON).

(*4): Set [UPnP] to OFF at [Network setting: Common] (→P. 16) (Default: ON).

If you communicate with remote sites (calling, call transferring, paging, etc.), make the remote site connection settings (→P. 12) after the network settings for your site have finished.

8