![](/images/new-backgrounds/1060186/6018611x1.webp)
➩Slide the cutter q over the film and all the way to the other side.
Note:
The film will only be cut when you slide the cutter q from left to right!
Sealing the film
Attention:
For sealing use only films made of
Attention:
Do not heat the supplied film, for example in a water- bath or similar. It is construed for temperatures of a maximum of 60°C.
➩Press simultaneously on the two unlocking devices left a and right i and open up the appliance cover u.
➩Lay the end of the film tube to be sealed over the sealing wire t.
➩Place the selector switch h into the position “Seal”.
➩Then close the appliance cover u. Ensure that the film tube does not slip off of the sealing wire t.
➩Press down the appliance cover u on the outer sides until it audibly clicks in at left and right.
➩Press and hold the broad button o with both
hands until the control lamp y lights up. Hold the button pressed down until the control lamp goes out.
Note:
To achieve the best results, press the button o down continuously, applying an even pressure
and using both hands.
Warning:
If the control lamp y does not go out after a maximum of 10 seconds, the appliance is defective! Immediately remove the plug from the wall socket. Do not attempt to repair the appliance yourself. In this case, contact Customer Services.
➩
Warning:
Fill the bags in such a way that, under no circum- stances, food remnants or fluids can run out of the bag when sealing it and permeate into the appliance.
- 4 -