Kompernass KH 2159 Programming by brand code search, Code Setup Programming the remote control

Code Setup (Programming the remote control)

3 Programming methods are available for the remote control: Programming by brand code search, by automatic code search and by direct code input (manual).

First you should use the brand code search since this method is the fastest way of programming if the manufacturer of your de- vice is itemized in the code list. As second is recommended the direct code input followed by the automatic code search.

Programming by brand code search

With this method you select the brand and code direct via the LCD display q.

Observe the following operational references to programme the remote control:

1.Press the device button e for the device that you want to programme the remote control.

2.Hold down the S button r for a little longer than 3 sec- onds. Carry out entries in the menu quickly because after approx. 15 seconds without an entry the menu will be ended.

3.In the LCD display q "CODE SETUP" appears. Press the OK button l. "ENTER CODE" now appears in the LCD display q. With the  buttons t select "BRAND

CODE" and confirm with the OK button l.

4.Now appears the alphabetical first brand name from the list of pre-programmed devices.

5.With the 34 buttons t select the various brand names.

6.To make access easier you can skip directly to specific let- ters of the alphabet with the number buttons o:

2	=> A	3	=> D	4	=> G	5	=> J
6	=> M	7	=> P	8	=> T	9	=> W

Example With button number 5 the display skips to the letter "J". The first brand is "JVC"*. If, for example, you own a "Kenwood"* brand device, continue leafing with the 4 button t until this brand name appears. (* All brand names used here are trademarks of the corre- sponding manufacturer.)

7.The majority of manufacturers use several different codes for the remote control. You must now ascertain which of the available codes is best suited to your device. On the right underneath the brand name the relevent code will be shown in the LCD display q.

8.Point the remote control to the relevent device and press the function buttons to test the code (except 4t, OK l, EXIT y, or the number buttons o).

- 11 -