4.The memory can accommodate 150 button commands.

If the memory is full the LCD display q shows "LEARN FULL" and the learn mode will end.

5.With the EXIT button y you return to the previous status (except with a notice of "LEARN KEY" and/or "LEARN- ING").

Code learn function

1.Press the device button e for the device that the URC should learn a button code.

2.Hold down the S button r for a little longer than 3 sec- onds. The notice "CODE SETUP" appears.

3.With the or button t select the menu "LEARN SETUP" and then press the OK button l.

4.In the LCD display q "LEARN SET" appears. Then press the OK button l. In the LCD display q "LEARN KEY" ap- pears.

5.First press the button on the URC that is to be taught. In the LCD display q "LEARNING" appears. The URC now waits for the infrared signal from the original remote control.

Note:

Should the notice not change to "LEARNING" you have selected a button for which no button code can be taught.

6.Point the infrared sensors 2) of both remote controls towards each other.

7.Now hold down the desired button of the original remote control until "SUCCESS" or "LEARN ERROR" appears in the display q of the URC.

8.If in the LCD display q "SUCCESS" appears (process successful), you can teach further buttons begining with step 5. If "LEARN ERROR" appears (process unsuccessful) repeat the process in any case from step 5.

9.To stop the learning process press, during the display “LEARN SET”, repeatedly the EXIT button y until the standard display is show in the LCD display q. During the notice "LEARN KEY" and/or "LEARNING" simply al- low 30 seconds to pass without any operation then the device will end the menu.

Delete All programmed buttons

1.Hold down the S button r for a little longer than 3 sec- onds. The notice "CODE SETUP" appears.

2.With the or button t select the menu "LEARN SETUP" and then press the OK button l. In the LCD display q "LEARN SET" appears.

3.With the or button t select "LEARN CLEAR"

(taught delete) and confirm with the OK button l. In the LCD display q "CONFIRM CLEAR" (confirm delete) appears.

4.Confirm with the OK button l. In the LCD display q "SUCCESS" appears. All programmed buttons are de- leted. Finally the menu will automatically end.

- 19 -

Page 21
Image 21
Kompernass KH 2159 manual Code learn function, Delete All programmed buttons