G2000T
9. Troubleshooting Guide
Case 1. Starting failure
Case 3. Oil does not come out
WARNING
Make sure the icing prevention system is not working.
Check fuel for water | a | fuel.Replace with proper |
or substandard mix- | ||
ture. |
|
|
|
|
|
Check oil for sub- standard quality.
d
Check oil passage and ports for clog- ging.
a
a
Replace.
Clean.
G |
B |
d
Check for engine flooding.
d
Check spark ignition.
a
a
Remove and dry the spark plug.
Then pull the starter again with no choke.
Replace with a new plug.
If the unit seems to need further service, please consult with an authorized service shop in your area.
Case 2. Lack of power/Poor acceleration/ Rough idling
Check fuel for water or substandard mix- ture.
a
Replace with proper fuel.
d
Check air filter and fuel filter for clog- ging.
a
Clean.
d
Check carburetor for inadequate ad- justment.
a
Readjust speed needles.
10. Disposal
When disposing your machine, fuel or oil for the machine, be sure to allow your local regulations.
11. Specifications
Power unit: |
|
|
|
|
Displacement (cm3): |
| 18.3 | ||
Fuel: | Mixture (Gasoline 50 : | |||
| (when using ZENOAH genuine oil) | |||
Fuel tank capacity (cm3): | ....................................... | 170 | ||
Chain oil: |
|
| Motor oil SAE# | |
Oil tank capacity (cm3): |
| 160 | ||
Carburetor: |
| Diaphragm type (Walbro) | ||
lgnition system: |
|
| Pointless (CDl) | |
Spark plug: |
|
| NGK CMR7A | |
Oil feeding system: | Automatic pump with adjuster | |||
Power |
|
| 0.64/9,000 | |
Max speed |
|
| 12,500 | |
Idle speed |
|
| 2,900 | |
Dimensions (L x W x H) (mm): | 270 x 190 x 190 | |||
Dry weight |
|
|
|
|
Power unit only (kg): |
| 2.2 | ||
Cutting head: |
|
Sprocket (Teeth x Pitch): | .................................. 8T x 1/4 |
Guide bar |
|
Type: | Sprocket nose |
Size (in. (mm)): | 8 (200) |
Saw chain |
|
Type: | Oregon 25AP |
Pitch (in. (mm)): | 1/4 (6.35) |
Gauge (in. (mm)): | 0.05 (1.27) |
Specifications are subject to change wihout notice.
