Operation

This avoids sparking, which often occurs when con- necting. Furthermore, this device is also controlled by an internal MCU (Micro-Computer-Unit), which makes it faster, more powerful and more reliable.

QReset / deleting settings

After connection to the power supply, the appliance automatically returns to its basic setting and remains in STANDBY mode

Q Switching over between modes 1, 2 and 3

jPress the selection button MODE 8 repeatedly to display the charging modes in the following order: Ready STANDBY, MODE1 , MODE2

, MODE3 and start the next cycle.

If you press the selector button 8 ,charging mode automatically switches over to the next mode and begins operation in that mode. However, if a battery is not disconnected from the charging station after a full charge, the appliance remains in trickle-charge mode, even if the user switches over to another mode. This protects the battery from being damaged.

QMode 1 (14.4 V / 0.8 A)

This mode is suitable for charging small batteries with a capacity below 14 Ah.

jPress the selection button MODE 8 , to select mode 1. After doing so, the corresponding LED

display 2 lights up. If you do not activate an-other process afterwards, the electronic sys- tem will automatically start the charging process

together with the LED display 7 at (with a current of) 0.8 A ± 10 %.

If the procedure runs without any problems, the

LED display 7 remains on during the entire charging process, until the battery is fully charged at 14.4 V / ± 0.25 V. When the battery is fully

charged, LED display 6 lights up and LED

display 7 goes out. The floating current is now available for the battery.

QMode 2 (14.4 V / 3.6 A)

This mode is mainly used for charging batteries with a large capacity exceeding 14 Ah under normal conditions.

jPress the selection button MODE 8 , to activate mode 2. If you do not activate another process afterwards, the electronic system, together with

LED display 3 starts the charging process at (with a current of) 3.6 A ± 10 % (3.6 A).

If the procedure runs without any problems, the

LED display 7 remains on during the entire charging process, until the battery is fully charged at 14.4 V / ± 0.25 V. When the battery is fully

charged, LED display 6 lights up and LED

display 7 goes out. The floating current is now available for the battery.

QMode 3 (14.7 V / 3.6 A)

This mode is used for charging batteries with a greater capacity than 14 Ah in cold conditions or for several AGM batteries with more than 14 Ah.

jPress the selection button MODE 8 , to activate mode 3. As soon as you have selected the suit- able charging mode, the corresponding LED

display 4 lights up immeditely. If you do not take any further action, the electronic system starts the charging process with a set delay. In this mode the charging current is identical to that of „Mode 2“.

If the procedure runs without any problems, the

LED display 7 lights up, the electronic stys- tem is active and remains in this condition until the battery is charged to approx. 14.7 V. As soon as this is reached, the charging station switches over to trickle-charging function. Now