Error messages

Table 3. Error messages

Symptom or error (beeps, if any)

FRU or action, in sequence

 

 

Bad CRC2. Enter BIOS Setup Utility, and load Setup

Press F1 to enter BIOS Setup Utility (ThinkPad Setup

defaults.

for ThinkPad X120e). Press F9, and Enter to load

(two short beeps)

the default setting. Then save the current setting by

 

pressing F10, and restart the computer.

 

 

 

Fan error.

1.

Fan.

(four short beeps, one long beep)

2.

Thermal grease.

 

3.

System board.

 

 

DRAM is unplugged.

Memory card is not installed. Install memory card.

(one short beep, pause, three short beeps, pause, three

 

 

short beeps, pause, one short beep.)

 

 

 

 

DRAM is not well plugged.

Reinstall the memory card.

(one short beep, pause, three short beeps, pause, three

 

 

short beeps, pause, one short beep.)

 

 

 

 

 

Operating system not found.

1.

Check that the operating system has no failure

 

 

and is installed correctly.

 

2.

Enter BIOS Setup Utility (ThinkPad Setup for

 

 

ThinkPad X120e) and see whether the hard disk drive

 

 

is properly identified. If you still see the same error

 

 

message, check the boot sequence.

 

3.

Reinstall the hard disk drive.

 

4.

Reinstall the operating system.

 

 

System Configuration Data Read Error

Press F1 to enter BIOS Setup Utility (ThinkPad Setup

(two short beeps)

for ThinkPad X120e). Press F9, and Enter to load

 

the default setting. Then save the current setting by

 

pressing F10, and restart the computer.

 

 

 

No-beep symptoms

Table 4. No-beep symptoms

Symptom or error

FRU or action, in sequence

 

 

 

No beep, power-on indicator on, LCD blank, and no

1.

Make sure that every connector is connected

POST.

 

tightly and correctly.

 

2.

DIMM.

 

3.

System board.

 

 

 

No beep, power-on indicator on, and LCD blank during

1.

Reseat DIMM.

POST.

2.

System board.

 

 

 

The power-on password prompt appears.

A power-on password or a supervisor password is set.

 

Type the password and press Enter.

 

 

The hard-disk password prompt appears.

A hard-disk password is set. Type the password and

 

press Enter.

 

 

 

LCD-related symptoms

Important: The TFT LCD for the notebook computer contains many thin-film transistors (TFTs). The presence of a small number of dots that are missing, discolored, or always lighted is characteristic of TFT LCD technology, but excessive pixel problems can cause viewing concerns.

36ThinkPad X100e and X120e Hardware Maintenance Manual

Page 42
Image 42
Lenovo X120E manual Error messages, No-beep symptoms, LCD-related symptoms