Table 1. FRU tests (continued)
FRU | Applicable test | |
|
| |
Speaker | Interactive Tests ➙ Internal Speaker | |
| Note: Once Audio test is done, the no sound is heard this test. In this case, turn off | |
| and turn on the computer. Then, run this test again. | |
|
|
|
Keyboard | 1. | Diagnostics ➙ Systemboard ➙ Keyboard |
| 2. | Interactive Tests ➙ Keyboard |
Hard disk drive or solid state | Enter the BIOS Setup Utility (ThinkPad Setup for ThinkPad X120e) and change Serial | |
drive | ATA (SATA) setting to Compatibility, and run Diagnostics ➙ Fixed Disks. | |
| For ThinkPad X100e, you can also diagnose the drive without starting up the operating | |
| system. To diagnose the drive from the BIOS Setup Utility, do as follows: | |
| 1. | Remove any diskette from the diskette drive, and then turn off the computer. |
| 2. | Turn on the computer. |
| 3. | While the message, “To interrupt normal startup, press the blue ThinkVangate |
|
| button,” is displayed at the lower left of the screen, press F1 to enter the BIOS |
|
| Setup Utility. |
| 4. | Using cursor keys, select HDD diagnostic program. Press enter. |
| 5. | Using cursor keys, select Main hard disk drive. |
| 6. | Press Enter to start the diagnostic program. |
|
|
|
Diskette drive | 1. | Diagnostics ➙ Diskette Drives |
| 2. | Interactive Tests ➙ Diskette |
Memory | 1. | If two DIMMs are installed, remove one of them and run Diagnostics ➙ Advanced |
|
| Memory Tests. |
| 2. | If the problem does not recur, return the DIMM to its place, remove the other one, |
|
| and run the test again. |
|
| |
TrackPoint or pointing | If the TrackPoint does not work, check the configuration as specified in the BIOS Setup | |
device | Utility (ThinkPad Setup for ThinkPad X120e). If the TrackPoint is disabled, select | |
| Automatic to enable it. | |
| After you use the TrackPoint, the pointer may drift on the screen for a short time. This | |
| drift can occur when a slight, steady pressure is applied to the TrackPoint pointer. | |
| This symptom is not a hardware problem. If the pointer stops after a short time, no | |
| service action is necessary. | |
| If enabling the TrackPoint does not correct the problem, continue with the following: | |
| • Interactive Tests ➙ Mouse | |
Touch Pad | If the Touch Pad does not work, check the configuration as specified in the BIOS | |
| Setup Utility (ThinkPad Setup for ThinkPad X120e). If the Touch Pad is disabled, select | |
| Automatic to enable it. If enabling the Touch Pad does not correct the problem, | |
| continue with the following: | |
| • Interactive Tests ➙ Mouse | |
Power system checkout
To verify a symptom, do the following:
1.Turn off the computer.
2.Remove the battery pack.
3.Connect the ac adapter.
4.Check that power is supplied when you turn on the computer.
5.Turn off the computer.
6.Disconnect the ac adapter and install the charged battery pack.
7.Check that the battery pack supplies power when you turn on the computer.
If you suspect a power problem, see the appropriate one of the following power supply checkouts:
•“Checking the ac adapter” on page 27
