Note:
Observe the colour coding:
•"White" CINCH plug to white
CINCH socket
•"Red" CINCH plug to red CINCH socket
•"Yellow“ CINCH plug to yellow
CINCH socket.
Connect the SCART double adapter (1() to the AV socket of your transmis- sion source (e.g. SAT receiver).
Adjusting the transmitter signals
The video transmitter (e) is designed so that a sufficiently high output voltage for faultless operation is supplied when simultaneously connected to a source (computer, DVD player, satellite receiver) together with other devices via the in- cluded adapter. The local TV switch (i) in the connection panel is then in the "YES" position.
If only the video transmitter (e) is con- nected to the video source, without another device such as a DVD player/ VCR), image disruptions may occur for some device combinations. In this case, set the slider switch (i) to "NO" (= no additional device connected). This lowers the signal power so that the video and sound are transmitted without distortions.
Note:
If the AV socket of your transmission source is already in use, use the out- put of the SCART double adapter (1() for the original connection . Connect the infrared cable (2#) to the infrared connection socket (u) of the trans- mitter. Tape one of the
Note:
Avoid attaching the transmission diode directly to the infrared receiver of your transmission source. Direct remote control commands can now be issued as usual.
Note:
Use the remaining transmission diodes for additional devices. You can then connect these devices with the trans- mission source. Connect the transmitter (e) with a connector power pack (2@) using the 6 V DC connection socket (t).
Connect the connector power pack (2@) with a 230 V~/ 50 Hz wall socket.
Use the "ON/OFF" switch (r), which is located on the side, to switch on the transmitter (e). Rotate the antenna for the remote control signals (q) upward. Orient the audio/video transmitter an- tenna (a).
Important!
The unlabelled side must point in the direction of the receiver (f).
Switch on your transmission source. If necessary, start playback on your trans- mission source (e.g. SAT receiver/set top box, DVD/CD player, VCR, PC etc.).
Connecting the receiver
Connect the other CINCH (RCA) cable (2!) to the receiver (f) and the SCART- CINCH adapter (2)).
Note:
Be sure to match the colours correctly.
- 7 -
