Konftel 300 Deleting Conference Groups, Delete All Conference Groups, Conference Guide Settings

CONFERENCE GUIDE

DELETING CONFERENCE GROUPS

Select MENU > CONF GUIDE > ERASE GROUP.

Mark the group you want to delete and press OK.

Confirm that you really want to delete the group by pressing OK or cancel the deletion of a group by pressing C.

DELETE ALL CONFERENCE GROUPS

Select MENU > CONF GUIDE > ERASE ALL.

Confirm that you really want to delete all groups by pressing OK or cancel the deletion of all groups by pressing C.

CONFERENCE GUIDE SETTINGS

When a multi-party call is going to be connected, a special signal (flash or R-pulse) is produced which transmits the command (request, return and conference) to the PBX. It may be necessary to change the type of signal if calls are connected via a PBX. Different PBXs may require different signals. These requirements should be specified in the techni- cal data for the PBX. Settings for the most common PBXs are listed on Konftel’s website.

Select MENU > CONF GUIDE > SETTINGS.

Enter the command for a request for a new dialling tone and press OK to confirm. (“F” is the default setting)

Enter the command to connect everyone to a multi-party call and press OK to confirm. (“F3” is the default setting)

Enter the command to return to your original call and press OK to confirm. (“F” is the default setting)

If you experience problems making multi-party calls

It may be necessary to change the duration of the Flash/R-pulse so that it works with your PBX. Read “ADJUSTING FLASH/R-PULSE DURATION” on page 23.

Your PBX may not be programmed to admit multi-party calls or the procedure may be different. Please contact your telephone administrator or service provider.

15