Konica Minolta Di1610p user manual When Incorrect Copies Are Produced

6.10 When Incorrect Copies Are Produced					6
Symptom	Possible Cause	Action
The copy has dark specks or spots.	The Original Glass surface is	Wipe the Original Glass clean
	dirty.	with a soft, dry cloth.
	The Original Pad is dirty.	Wipe the Original Pad clean
		with a soft cloth dampened with
		neutral detergent.
	The original is highly	Place a blank sheet of paper
	transparent.	over the original.
	The original is 2-sided.	If a thin double-sided document
		is being copied, the information
The copy has lines.		on the back side may be
		reproduced in the copy. Press
		the [	Ö	] key and select a lighter
		copy density.
	Something is sticking to the	Wipe the Original Glass clean
	Original Glass (when the Auto	with a soft, dry cloth.
	Document Feeder is used).
	The Drum Cartridge has	Contact your service
	reached the end of its service	representative.
	life.
The image on the copy is not aligned	The original is not placed in the	Place the original correctly on
properly.	correct position.	the Original Glass against the
		Original Scales.
		Or, load it in the Auto
		Document Feeder correctly
		along the Document Guide
		Plates.
	The original may not be	Raise the Auto Document
	suitable for use in the Auto	Feeder and place the original
	Document Feeder.	on the Original Glass correctly
		against the Original Scales.
	The paper guides are not	Slide the paper guides against
	pressed up against the paper	the edges of the paper stack.
	stack in the tray.
	The paper has an excessive	Smooth out curls in the paper
	curl.	and reload the paper stack in
		the tray.
The printed page is curled.	The paper that was used curls	Remove the paper from the
	easily (as with recycled paper).	paper tray, turn it over, and
		then load it again.
		Change the paper.

When a Message Appears Chapter 6

Di1610/Di1610p 6-27