Konica Minolta FRS-1000 manual Transmit Power Selection Mode

CTCSS filters out unwanted transmissions without the same coded squelch tone). To change the CTCSS Sub-channel,

- From the FRS standby mode, press the MODE Button twice; the sub- channel number will flash as it is displayed. If oF is displayed, press the Up or Down button to enable the CTCSS mode; the CTC icon will appear steady on the display with the flashing sub-channel number.

-Then press the Up or Down button to select the desired sub-channel for use.

-Press the Power On/Off button momentarily to confirm selection.

The CTCSS mode can be turned off by selecting the oF icon with the Up or Down button.

NOTE: To communicate with other FRS units, they must be switched to the same channel and CTCSS subcode. To communicate with other FRS units that do not have subcodes, switch your unit to the same channel with the subcode set to oF.

The CTCSS subcodes do not prevent others from hearing your transmission. This will only allow you to ignore all traffic on a given channel not using the same subcode.

Transmit Power Selection Mode

This feature permits selection of the transmitting power level at high or low. When set to low, the transmit range of the unit will be less; however, battery life will be increased.

To access the transmitter power selection function:

-Press the Mode Button 3 times until the Po icon appears with a flashing HI or Lo indication on the display.

-Press the Up or Down button to toggle between the High and Low se- lections.

-Momentarily press the Power Button to confirm selection.

The display will indicate the current setting in standby mode.

12