Others/Connecting camera with personal computer

●For the working environment of a personal computer, refer to the installa- tion manual.

●Install the required software in your personal computer. Before starting operation with the installed software, be sure to read the instructions “Readme” supplied with the software.

●Confirm that the lens barrier is closed, a recorded CF card is set in the camera and the camera is turned on with power supplied from batteries or an AC adaptor.

●To save the battery power, it is recommended to use an optional AC adaptor as a power source for the camera.

●Turn off the personal computer without fail.

1.Open the camera's I/O terminal cover and connect the camera and a personal computer with each other by means of the connecting cord.

*Plug the 8-pin connector of the connecting cord into the camera's serial port jack. To disconnect the connecting cord from the camera’s serial port, refer to the instruction manual for Q-M100.

ⓐTo serial port of personal computer.

ⓑSince the type of personal computer’s connector differs from personal computer to personal computer, carefully read the installation manual and

use a proper connector or adaptor for connecting the cord.

ⓒPersonal computer (optional)