Operating Your
7 Operating Your FC-4046 Video MultiCoder®
Operate your
The front panel buttons
7.1Using the Front Panel Buttons
Section 7 .1.1 describes how to convert (encode) RGB or YUV input signals to composite or Y/C video output signals and vice versa (decode).
7.1.1Encoding and Decoding Video Signals
To encode/decode a video signal, do the following:
Select the desired input using the INPUT button The illuminated INPUT LED indicates the selected input
7.1.2Adjusting the CONTROL Levels
To adjust a specific CONTROL level:
1.Press the appropriate CONTROL button.
The CONTROL button illuminates and the
2.Press the + button or - button once to gradually increase or decrease the current level by one unit.
The
To increase or decrease the current level rapidly, press and hold down the + button or - button, continuously2. To end the rapid adjustment, release the + button or – button.
7.1.3Locking the Front Panel
To prevent changing the settings accidentally or tampering with the front panel, lock your
To lock the
Press the PANEL LOCK button (for about 2 seconds) until the PANEL LOCK LED illuminates freezing the front panel controls. Pressing a button will have no effect, except to cause the PANEL LOCK LED to blink3. Nevertheless, even though the front panel is locked you can still operate your PC control software.
1 It could be pressed again to choose the “other” CONTROL function on the button
2 The
3 Warning that you need to unlock to regain control via the front panel
10 | KRAMER: SIMPLE CREATIVE TECHNOLOGY |
