Kramer Electronics fc-42 user manual Connecting the FC-42

5 Connecting the FC-42

i	Always switch off the power to each device before connecting it to your
	FC-42. After connecting your FC-42, connect its power and then switch
	on the power to each device.

To connect the FC-42, as illustrated in the example in Figure 3, do the following:

1.Connect a component video source (for example, an HDTV Satellite receiver source) to the Y, PB, PR INPUT BNC connectors.

2.Connect the OUTPUTS:

Connect the SDI BNC connector to an HD-SDI acceptor (for example, a non-linear editor)

Connect the SDI BNC connector to an HD-SDI acceptor (for example, an HD-SDI display)

Connect the RGB/HV 15-pin HD computer graphics video connector to an RGBHV acceptor (for example, a projector)

3.Connect a PC or other controller, if required (see Section 5‎ .1).

4.Connect the power cord (not shown in Figure 3).

8 FC-42 - Connecting the FC-42