Kramer Electronics SV-551

Installing Optional Ceiling Speakers

2. Place the tile rails on the tile and snap them into the two tabs on the C-ring.

Align the rails so that the ends extend over the T-channel grid.

3. Insert a screw through each tab on the C-ring to secure the rails.

4. Connect the speaker wires to the appropriate connector terminals1 and screw

the hold-down screws on the connector until tight.

Figure 8: Wiring a Pair of Speakers to the SV-551

5. Plug the connector into the socket in the terminal cup of the speaker and

tighten the screws (see Figure 9).

6. Loosen the horizontal screw and then the strain relief screws.

7. Run the wires through the opening in the fitting and plug the input connector

into the terminal block connector of the speaker.

Figure 9: Plugging and Securing the Cables

1 Pin 1 and Pin 2 are connected internally and are positive (+). Pin 3 and Pin 4 are connected internally and are negative (-)

Contents

Main Kramer Electronics, Ltd. USER MANUAL Models: Page Page 1 Introduction 2 Getting Started PART I Your SummitView System 3 Overview Page Page Page PART II The SV-551 SummitView Processor/Switcher 4 Defining the SV-551 SummitView Processor/Switcher Figure 1, Figure 2 and Table 2 define the SV-551 SummitView Processor/Switcher. Page Page PART III Detailed Installation Instructions Defining the SV-551 SummitView Processor/Switcher 11 Table 3: Defining the RC-63DL1 Page Defining the SV-551 SummitView Processor/Switcher 13 4.4 SV-301 and SV-302 (U.S.) Table 4 defines the front and rear views of the SV-301 and SV-302. Table 4: Defining the SV-301 and SV-302 (U.S.) Defining the SV-551 SummitView Processor/Switcher 14 ) Table 5: Defining the SV-301 (England and Europe)2 Table 6: Defining the SV-302 (England and Europe)2 Page Page Page 5 Installing Optional Ceiling Speakers Page Page Page Page Page Page Page Page Page PART IV Further information 6 ADA Requirements Page 7 Customizing the Controllers' Buttons and Labels 8 Wiring the CAT 5 LINE IN/LINE OUT RJ-45 Connectors Page SummitView System Cables Video DDC 33 9 SummitView System Cables Table 10 defines the recommended cables for a SummitView installation. Table 10: Cables included with the SV-551 SummitView Essentials Kit and SV-551 ALC SummitView System Cables 34 10 SummitView Cable Termination (Connector-to-Cable) Table 10 defines the SummitView Cable Termination. Page Technical Specifications 37 11 Technical Specifications Table 13 includes the technical specifications of the SV-551. Table 13: Technical Specifications1 of the SV-551 Kramer 12 Detachable SummitView Essentials Kit Check List