Krell Industries 7, 5, 6 manual Questions and Answers

Questions and Answers

Q.Should I turn the Showcase Amplifier off (unplug the amplifier) when not playing music?

A.No. Leave the Showcase Amplifier in the stand-by mode when not playing music. The stand-by mode avoids cold starts as well as minimizes heat output and power consumption. Turn the amplifier off if you plan to be away for a period of time, for example, on vacation. See Amplifier Operation, on page 12.

Q.When I turn the amplifier on there is a loud hum through the loudspeakers. What should I do?

A.When a new component is introduced, a low frequency hum may occur in one or both loudspeakers. Check that all input and output connections and cables are of sound construction. See Troubleshooting System Noise, on page 13. If the con- nections and cables are sound, you may be experiencing a ground loop. This can often be easily eliminated. Please contact your authorized Krell dealer, distributor, or Krell for suggestions.

Q.When I connect the amplifier to my system using the single- ended inputs, a loud buzz comes from my loudspeakers. What is it?

A.Check that the shorting pins for the Showcase Amplifier are inserted into the XLR inputs (the unit is shipped with the pins in place). When using the single-ended inputs, shorting pins must be inserted between pins 1 and 3 to keep external noise from corrupting the signal. For more information, see Connecting the Showcase Amplifier to Your System, on page 10.

Q.I cannot turn the amplifier on. Why not?

A.Make sure the stand-by LED is not flashing. If the stand-by LED is flashing, unplug the amplifier from the AC wall receptacle and then plug it back into the AC wall receptacle. If the stand-by LED continues to flash, contact your Krell-authorized dealer or distributor, or Krell. If no LEDs are illuminated, check the power cord and check the AC mains fuse. To remove the fuse, unplug the power cord from the amplifier and slide out the fuseholder.

Q.I get no signal from one of the amplifier channels when the unit is on. Why not?

A.Make sure you are not connected to channels 6 or 7 on a Showcase 5, or to channel 7 on a Showcase 6. If you are using the single-ended input, make sure the shorting pin is inserted between pins 1 and 3, and not between pins 2 and 3.

14 Krell Showcase Amplifier